Advertisement
2
Installation
•
The installation includes 6 major steps:
1. Read the operation manual.
2. Plan where to install the transducers and instruments.
3. Run the cables.
4. Install the transducers and instruments.
5. Take a break and admire your installation.
6. Learn the functions and calibrate your system.
Before you begin drilling ... think about how you can make the installation as neat
and simple as your boat will allow. Plan where to position the transducers, Server
and instruments. Think about leaving space for additional instruments in the future.
A few "do nots" you should consider:
Do not cut the cables too short. Allow extra cable length at the Server so it
can be disconnected for inspection without having to disconnect all
attached cables.
Do not place sealant behind the display. The instrument gasket eliminates
the need for sealant.
Do not run cables in the bilge, where water can appear.
Do not run cables close to fluorescent light sources, engine or radio
transmitting equipment to avoid electrical disturbances.
Do not rush, take your time. A neat installation is easy to do.
•
The following material is needed:
Wire cutters and strippers.
Small flat head screw driver.
Hole saw for the instrument clearance hole 63 mm (2½ ").
5 mm (
Plastic cable ties
If you are doubtful about the installation, obtain the services of an experienced
technician.
If the Network cable is too short, you can use the extra Network cable 8m or you
can use spare cable from your installation.
1
/
") drill for the mounting holes.
4
9
Hide quick links:
Advertisement
