Slant/Fin VICTORY VSPH/NDV-60 Installation And Operating Instructions Manual page 9

V
ICTORY VSPH Models
VICTORY VSPH/NDV MODELS, SIDEWALL VENTING
BUILT-IN
CONDENSATION
DRAIN & TRAP
PRESS./TEMP.
GAUGE
FILL TRAP
WITH WATER
AIR INTAKE
W
(DO NOT BL0CK)
VSPH/NDV BOILER
Figure 5. Side wall venting.
STANDARD 90?
ELBOW
BUILT-IN
CONDENSATION
P
DRAIN & TRAP
PRESS./TEMP.
GAUGE
FILL TRAP
A
WITH WATER
AIR INTAKE
(DO NOT BLOCK)
VSPH/NDV BOILER
Figure 6. Side wall venting.
Definition of Snow Line: Knowledge of local conditions will reveal the maximum height that repeated snowfalls accumulate to.
The height should be used as the SNOW LINE.
AL 29-4C IS A REGISTERED TRADEMARK OF ALLEGHENY LUDLUM CORP
*
All joints must be liquid and pressure tight. Use U/L listed single wall 3" dia.
AL29-4C S.S.*. venting materials (See page 5).
2 FT.MIN.
SLOPE UP 1/4 IN.
PER FOOT MIN.
FROM BOILER TO
VENT TERMINATION
3 IN. DIA.
S.S.FLUE
PIPE (SEE
PAGE 5)
TO DRAIN OR
CONTAINER
V
SLOPE UP 1/4 IN.
PER FOOT MIN.
FROM BOILER TO
VENT TERMINATION
S
O
STANDARD 90? ELBOW
OR
TIGHT RADIUS 90? ELBOW
TO DRAIN OR
CONTAINER
S.
V
6 IN. MIN.
9 IN. MAX.
OUTSIDE VENT TERMINATION
ELBOW WITH SCREEN
A WALL THIMBLE MUST
BE USED ON COMBUSTIBLE
WALLS. S/F P/N 440695
(ADJUSTABLE 5 IN. TO 8 IN.)
MAY BE USED. ABOVE THIMBLE
A WAL
MUST BE USED WITH HEAT-FAB
3 SLIP JOINT CONNECTOR
OUTSIDE WALL
9
OUTSIDE VENT TERMINATION
A U
A U/L LISTED WALL THIMBLE
MUST BE USED ON COMBUSTIBLE
3 IN. DIA. 3 IN. DIA.
WALLS. S/F P/N 440695
S.S.FLUE
(ADJUSTABLE 5 IN. TO 8 IN.)
PIPE (SEE
MAY BE USED. ABOVE THIMBLE
PAGE 5)
MUST BE USED WITH HEAT-FAB
SLIP JOINT CONNECTOR
O
OUTSIDE
WALL
.
12" MIN
SNOW LINE
(SEE DEFINITION)
6 IN. MIN.
9 IN. MAX.
ELBOW WITH SCREEN
12" MIN
SNOW LINE
(SEE DEFINITION)
9