Table of Contents
Advertisement
Menu List
Note
The following conventions are used in the menu list table.
Settings column values (e.g. ON, OFF, 0): Default settings
Execute via ENTER: Press the CONTROL knob or move the CANCEL/ENTER lever to the ENTER position to execute.
SYSTEM OPERATION menu
SYSTEM OPERATION
Page name
Item
Page No.
<OUTPUT SELECT>
OUTPUT
S01
PIX
WFM
<GENLOCK PHASE>
CONTROL
S02
REFERENCE
GENLOCK
<MULTI FORMAT>
FREQUENCY
S03
Note
CAMERA FORMAT
FREQUENCY or
HD-SD DELAY
CAMERA FORMAT mode
setting changes take effect
only after the CCU power
COMPONENT
supply is turned off and
then on again.
Settings
CAMERA, BAR, TEST1, TEST2
ENC, R, G, B, R&G, G&B, R&B,
RGB
ENC, R, G, B, SEQ, R&G, G&B,
R&B, RGB
(REMOTE), (LOCAL)
(NONE), (EXT IN)
HD, SD
(OK), (NG)
External reference signal format
H STEP
When GENLOCK mode is HD:
–3.01 to 3.45 µsec 0.00
When GENLOCK mode is SD:
–8.29 to 9.48 µsec 0.00
COARSE
–99.9 to 99.9 0
V PHASE
0 to 7
SUB-REF
(NONE), (EXT IN)
Note
(UNKNOWN), (Frame Gate), (HD),
(SD)
Displayed only
when HKCU1003
is connected
HD
1.000
SD
(625PAL)
1080/50I
Line (90H), Frame (1F), 0-Delay
RGB, YCD
Description
Selects the output signal.
TEST1 and TEST2 are not selectable if there is no
communication with the camera.
Selects the PIX connector output signal.
Selects the WFM connector output signal.
Displays the status of the reference signal input.
This unit's GEN LOCK mode: displays the lock
status and format.
HD: HD
SD: SD
Sets the lock status of the external reference signal.
(OK): Locked
(NG): Unlocked
Displayed only when a reference signal is present.
Horizontal phase (STEP)
Displays the sub-reference signal format.
Horizontal phase
Displays the sub-reference signal format.
Vertical phase (line)
Displays the sub-reference signal format.
Displayed only when a sub-reference signal is
present.
Sub-reference signal format display
Displays the operating frequency.
Displays the transmission format.
Sets the phase output for SD signals down
converted from this unit's HD signals.
Selects the component signal connector's output
format.
(Displayed only when HKCU1003 is installed.)
25
Setup Menu
Advertisement
Table of Contents
