Sony HDCU2080 Operation Manual page 30

Hd camera control unit
Hide thumbs Also See for HDCU2080:
Table of Contents

Advertisement

CCU
CONFIGURATION
Page name
Page No.
<INTERCOM>
C08
<FRONT INCOM>
C09
30
Setup Menu
Item
Settings
INTERCOM CH
1CH, 2CH
SYSTEM INTERFACE
PRODUCER
4WIRE, RTS, CLEAR COM
CANCEL LVL
–99 to 99 0
TERMINATION
(OFF), ON
ENGINEER
4WIRE, RTS, CLEAR COM
CANCEL LVL
–99 to 99 0
TERMINATION
(OFF), ON
PGM1 INPUT
–20, 0, +4 dBu
PGM2 INPUT
–20, 0, +4 dBu
(MIC ON), (MIC OFF), (PGM ON)
(PROD), (ENG), (PRIVATE)
INCOM MIC
CARBON, ECM, DYNAMIC
MIC TYPE
BALANCE, UNBALANCE
MIC GAIN
–6dB, 0dB, +6dB
SIDE TONE
0 to 99 50
PGM MIX
OFF, INCOM+PGM, L-INCOM/R-
PGM
PGM SEL
PGM1, PGM2, PGM1 + PGM2
PGM1 LVL
0 to 99 50
PGM2 LVL
0 to 99 50
Description
Selects the intercom channel number.
Sets the producer line intercom system.
Sets the side tone cancel level.
Connects to a 200 Ω terminator, if ON is selected
while 2-wire intercom interface (RTS or CLEAR
COM) is used.
(OFF): Displayed when 4WIRE is selected in
SYSTEM I/F. (Display only)
Sets the engineer line intercom system.
Sets the side tone cancel level.
Connects to a 200 Ω terminator, if ON is selected
while 2-wire intercom interface (RTS or CLEAR
COM) is used.
(OFF): Displayed when 4WIRE is selected in
SYSTEM I/F. (Display only)
Sets the PGM1 input level.
Sets the PGM2 input level.
CCU front panel MIC/PGM switch position. (Display
only)
CCU front panel INTERCOM switch position.
(Display only)
Sets the headset microphone connected to the
INTERCOM connector on the front panel.
CARBON: Carbon microphone (power supply, 20dB
gain)
ECM: Electret condenser microphone (power
supply, 40dB gain)
DYNAMIC: Dynamic microphone (no power supply,
60dB gain)
Sets the headset microphone connected to the
INTERCOM connector on the front panel.
BALANCE: Balanced microphone
UNBALANCE: Unbalanced microphone
Sets the input gain.
Sets the side tone level.
OFF: Signals are not mixed.
INCOM+PGM: INCOM and PGM signals are mixed.
L-INCOM/R-PGM: Outputs an INCOM signal
through the left channel and a PGM signal through
the right.
Selects the PGM type.
Sets the PGM1 level.
Sets the PGM2 level.

Advertisement

Table of Contents
loading

Table of Contents