Table of Contents
Advertisement
CCU
CONFIGURATION
Page name
Item
Page No.
<PROMPT/TRUNK>
PROMPTER
C10
TRUNK SETTINGS
TRANSMIT
CABLE
AUX REMOTE
<VIDEO SETUP>
SETUP
C11
SD BLK CLP
Q FILTER
G/Y SYNC
VCS RELAY
<VIDEO ADJUST 1>
VBS
C12
(Available when a
HKCU1001 or HKCU1003
board is installed)
PIX
WFM
<VIDEO ADJUST 2>
VBS
C13
(Available when two
HKCU1001 or HKCU1003
boards are installed)
PIX
WFM
(Available when yet
G/Y LEVEL
another VDA board from
B/B-Y LEVEL
the HKCU1003 is installed
R/R-Y LEVEL
to the option slot)
Settings
1CH, 2CH
(38Kbps), (19Kbps)
CH
1CH, 2CH
IF
232C, 422A
AUTO, HIGH BIT RATE, HD-SDI,
(HD-SDI)
CAMERA CABLE, COAX
DISABLE, ENABLE
ON, OFF, ---
OFF, ON
WD, NA
OFF, ON
OFF, ON
LEVEL
–99 to 99, 0
CHROMA
–99 to 99, 0
LEVEL
–99 to 99, 0
CHROMA
–99 to 99, 0
LEVEL
–99 to 99, 0
CHROMA
–99 to 99, 0
LEVEL
–99 to 99, 0
CHROMA
–99 to 99, 0
LEVEL
–99 to 99, 0
CHROMA
–99 to 99, 0
LEVEL
–99 to 99, 0
CHROMA
–99 to 99, 0
–99 to 99, 0
–99 to 99, 0
–99 to 99, 0
Description
Sets the number of prompter lines.
Displays the TRUNK line. (Display only)
Sets the number of channels to be used.
Sets the communication line mode.
Sets the optical transmission rate between the
camera and CCU.
Sets the transmission format between the camera
and CCU.
Sets whether or not AUX REMOTE is used.
ON: Adds a setup signal to VBS and SD YCD
component signal Ych-SYNC.
OFF: No setup signal is added.
---: Displayed when the format is PAL. (Display only)
Y signals from SD SDI output that are less than 0%
are clipped at 0%.
Sets the Q filter bandwidth. (Displayed only when
HKCU1001 or HKCU1003 is installed.)
Sets the R/G/B component signal's G ch-SYNC to
on/off. (Displayed only when HKCU1001 or
HKCU1003 is installed.)
Sets the PIX/WFM connector output. (Displayed only
when HKCU1001 or HKCU1003 is installed.)
Adjusts the VBS output video level.
Adjusts the PIX output video level.
Adjusts the WFM output video level.
Adjusts the VBS output video level.
Adjusts the PIX output video level.
Adjusts the WFM output video level.
Adjusts the G/Y output video level.
Adjusts the B/B-Y output video level.
Adjusts the R/R-Y output video level.
31
Setup Menu
Advertisement
Table of Contents
