Storing The Cleaner; Section 5. Maintenance - Polaris EM27 Series Owner's Manual

Page 12
4.8

Storing the Cleaner

The cleaner must be cleaned regularly using slightly
soapy clean water. Do not use solvents such as acetone or
its equivalent. Rinse the cleaner generously using clean
water. Do not let your cleaner dry in direct sunlight near
the pool. The cleaner must be stored on its caddy so that
it dries quickly.
1. Starting at the cleaner head. Remove all coils and
tangles from the cable (see Figure 20).
Figure 20. Untangle the Floating cable
2. Place the cleaner in vertical position on the
caddy base with the rear tracks on the caddy side
wedges (see Figure 21).
3. Loosely coil the power cable starting at the
cleaner and moving toward the connection point
at control unit. Store the cable by wrapping it
around the hook located on the front of the caddy
(see Figure 21).
4. Disconnect the cable from the control unit and
coil loosely around the caddy hook.
5. If you removed the control unit from the caddy,
replace it by aligning the bottom of the control
unit with the caddy notch, hook it onto the
caddy, then press firmly in place until you hear
a "click".
Figure 21. Cleaner Stored Correctly on Caddy

Section 5. Maintenance

WARNING
To avoid electric shock and other hazards which
could result in serious injury or death, disconnect
(unplug) the cleaner from the power source before
performing any cleaning and maintenance.