Connecting The Control Unit To The Caddy; Connecting To A Power Source - Polaris EM27 Series Owner's Manual

Page 6
Figure 7. Fully Assembled Transport Caddy
3.3 Connecting the Control Unit to the
Caddy
1. Align the bottom of the control unit with the
notch at bottom of the control unit hook on the
caddy (Figure 8).
Figure 8. Align Control Unit on Caddy Hook
2. Press control unit onto the caddy hook until it
snaps and locks into position (Figure 9).
Figure 9. Attach the Control Unit onto Caddy
3.4

Connecting to a Power Source

WARNING
Failure to comply with the following warnings can
result in permanent injury, electrocution or drowning.
PREVENT ELECTRICAL SHOCK
• U.S.: Per NEC requirements, keep the control unit
®
at least five (5) ft. (1.5 m) from the edge of the pool.
CANADA: Per CEC requirements, keep the control
unit at least three (3) m (10 ft.) from the edge of the
pool.
• Only connect the control unit to a receptacle
protected by a ground fault circuit interrupter
(GFCI). Contact a certified electrician if you cannot
verify that the receptacle is protected by a GFCI.
• Do not use an extension cord to connect the control
unit.
• Do not allow anyone to swim while the cleaner is in
the pool.
• The control unit is water-resistant, not waterproof.
In order to prevent electrocution, never submerge
the control unit or leave exposed to inclement
weather.
To Connect:
• Rotate the power cord so that TOP is shown on
the top side. Press the power cord firmly into
the control unit until you hear a "click" (see
Figure 10). The clicking indicates the power
cord is connected correctly creating a watertight
seal.