Table of Contents
Advertisement
Page 12
4.7
Storing the Cleaner
The cleaner must be cleaned regularly using slightly
soapy clean water. Do not use solvents such as acetone
or its equivalent. Rinse the cleaner generously using
clean water. Do not let your cleaner dry in direct
sunlight near the pool. The cleaner must be stored on its
caddy so that it dries quickly.
1.
Starting at the cleaner head. Remove all coils
and tangles from the cable (see Figure 19).
Figure 19. Untangle the Floating cable
2.
Place the cleaner in vertical position on the
caddy base with the rear tracks on the caddy
side wedges (see Figure 20).
3.
Loosely coil the power cable starting at the
cleaner and moving toward the connection
point at control unit. Store the cable by
wrapping it around the hook located on the
front of the caddy (see Figure 20).
4.
Disconnect the cable from the control unit and
coil loosely around the caddy hook.
5.
If you removed the control unit from the caddy,
replace it by aligning the bottom of the control
unit with the caddy notch, hook it onto the
caddy, then press firmly in place until you hear
a "click".
Figure 20. Cleaner Stored Correctly on Caddy
Section 5. Maintenance
WARNING
To avoid electric shock and other hazards which
could result in serious injury or death, disconnect
(unplug) the cleaner from the power source before
performing any cleaning and maintenance.
5.1
Avoid Cord Tangling
During cleaning, always allow enough floating cable to
reach across the farthest length of the pool but do not let
excessive cable in the pool. Excessive cable length may
cause tangling or affect the cleaning pattern
(see Figure 21).
Hide quick links:
Advertisement
Table of Contents
