Table of Contents
Advertisement
To install the main unit on the wall
Preparation:
Remove the stand from the main unit (perform steps 1 - 2 on page
15).
Sharp has designed the
main unit so you can hang
3.2 mm (1/8")
5 mm (3/16")
it on the wall.
Use appropriate screws
(not supplied). See the il-
lustration on the right for
size and type.
Min. 22 mm (7/8") 9 mm (3/8")
1
Make a hole in the wall using
a drill.
8-9 mm (3/8")
2
Drive a wall mount plug into
the hole using a hammer,
until it is flush with the wall
surface.
3
Drive two screws into the wall for main unit, as shown in
the illustration.
Make sure that both the screw and the wall can support a load
of 2.2 kg.
Drive the screws, so the screw head extends about 5.5 mm (7/
32") out from the wall.
Wall surface
Wall mounting screw
Wall surface
4
Fix the pattern paper and drive two screws into the wall
with a distance of 130 mm (5-3/25") in between.
1 3 0 m
5
Tighten the screws and remove the paper. Hook the main
unit on the screw heads and make sure it is secure.
32 mm (1-1/4")
Wall surface
CAUTION:
Make sure to prevent the main unit (2.2 kg) from falling when
mounting on the wall.
Before mounting, check the wall strength. (Avoid the veneer plas-
ter or whitewashed wall. The main unit may fall.) If it is not clear,
consult with a qualified service technician.
Mounting screws are not supplied. Use appropriate ones.
Check all mounting screws for looseness and that they are
engaged in the main unit.
5.5 mm (7/32")
Mount the main unit on the wall with 2 screws.
Select a good location. If not, accidents may occur or the main
unit may get damaged.
Avoid placing on a bed, sofa, water tank, sink and hallway wall.
SHARP is not responsible for accidents resulting from improper
installation.
05/6/7
HT-X15H(H)E7.fm
)
3 / 2 5 "
m ( 5 -
Pattern paper
for main unit
TINSZA064SJZZ
HT-X15H
ENGLISH
8
E-66
Advertisement
Table of Contents
