Main Unit Preparation - Sharp SD-AS10H Operation Manual

Main unit preparation

Make sure to unplug the AC power lead before installing the main unit or change the position.
Select from three installation methods according to the location.
For position A or B, make sure to use the included main unit stand. Otherwise the unit may fall.
The display direction changes according to the installation direction.
Position A
1
Remove the 2 screws.
2
Secure the stand with the removed screws.
Main unit
stand
YES
Correct
Notes:
" When attaching the stand, place the main unit on a cushion or soft cloth to avoid
damage.
" Use the removed screws to secure the stand. Otherwise, the unit may break.
" Remove the only specified screws. Otherwise malfunction may occur. Be careful
not to lose the removed screws.
" Attach the button name label carefully. It is difficult to peel off.
Position B
1
Remove the 2 screws.
Make all connections
before attaching the
stand (see pages
14 - 16).
2
Secure the stand with the removed screws.
Main unit
stand
NO
Caution:
" Do not change the installation direction when the main unit is turned on. Discs may
not be read or may be damaged.
" To turn on the power after the first installation or after changing the installation
method, use the ON/STAND-BY button on the main unit. From the next time, you
can also use the remote control.
05/3/17
Position C
1
Align the position with the remote sensor
and attach the included button name label.
Button name label
Remote
sensor
2
Fit the non-slip sheets into the groove.
YES
Correct
NO
Non-slip sheet for main unit
SD-AS10H_SEEG_E.fm
SD-AS10H
ENGLISH
D
F
S
V
I
N
P
E
E-12
TINSZA116AWZZ