2-3.
TOP PANEL BLOCK-1
• Continued on 2-4 (page 12).
Note: During reassembly, use new insulock ties
9 flexible flat cable (7P) (CN601)
NG
microphone
microphone
wire
wire
Wire
front side
The opposite side
is terminal side.
CN601
The opposite side
is terminal side.
CN3001
CN120
to fasten the wires back in place as they
were before disassembly.
1 Cut the insulock tie.
0 flexible flat cable (7P) (CN120)
(from GESTURE board)
(from MIC board)
front side
right side
5 microphone wire connector
(CN3001)
6 flexible flat cable (6P) (CN105)
(from NFC board)
7 flexible flat cable (19P) (CN103)
(from PANEL board)
–
–
terminal side
CN103
CN105
The opposite side
is terminal side.
front side
4 MIC board wire
2 screw
3 PANEL board wire
(BVTP3
8)
rear side
MIC board wire
PANEL board
cable
MOTHER
board
CN451
–
MHC-V41D
top side
rear side
8 PANEL board cable
connector (CN451)
rear side
PANEL board wire
–
insulock tie
11