Mother Board - Sony MHC-V41D Service Manual

MHC-V41D

2-15. MOTHER BOARD

Note 1: Make sure perform discharge processing before removing the
MOTHER board. For the discharge processing method, refer
to "CAPACITOR ELECTRICAL DISCHARGE PROCESS-
ING" on page 5.
2 SMPS board cable
connector (CN001)
(See Note 1)
6 six screws
(BVTP3 8)
front side
4 filament tape
(sub material)
(See Fig. N)
4 filament tape
(sub material)
(See Fig. N)
< Fig. N >
MOTHER board
– –
– Bottom view –
front side
filament tape
(sub material)
22
3 MOTHER board cable
connector (CN6500)
(See Note 1)
1 Remove the two cables
from the coating clip.
(See Fig. M)
rear side
SMPS board
hole
MOTHER board
cable
MOTHER board
cable
filament tape
(sub material)
Note 2: When the MOTHER board is replaced, refer to "DESTI-
NATION SETTING METHOD" and "NFC OPERATION
CHECKING METHOD" on page 6.
< Fig. M >
CN001
MOTHER
board
MOTHER board cable
chassis block
5 screw
(P3 8)
qa MOTHER board (See Note 2)
hole
7
hole
8 Draw the connector
and jack out of the
hole in chassis.
rib
rib
– Top view –
SMPS board
SMPS board cable
coating clip
Note 3: When installing the MOTHER board,
align the two ribs and two holes.
0 MOTHER board cable
connector (CN2007)
9 Draw the MOTHER
board cable out of
the hole in chassis.
(See Fig. N)
hole
front side
CN6500