Lorex SG6350 Instruction Manual page 11

INSTALLATION OF RECEIVER
CONNECTING A RECEIVER TO A TV USING COAXIAL CABLES
B)
Back of Receiver
Ensure the Power Switch on the Receiver is turned OFF prior to
NOTE
proceeding with the following steps.
1. Place the wireless receiver near your television (or monitor).
2. Connect one end of the coaxial cable to the back of the Receiver. Plug the
other end of the coaxial cable to the television.
3. Connect one end of the supplied 9V 500mA AC adapter into the DC IN jack
at the back of the receiver; the other end into an electrical outlet. Turn the
receiver ON. The system is defaulted to channel 1.
4. Search channels 1 through 4 by using Channel Selector Switch on the
Receiver and Camera.
5. Turn your TV to channel 3 to view the picture.
6. Adjust the antenna on both the camera and receiver as necessary for
optimum viewing.
For optimum viewing reception you may need to change the
NOTE
channels of your camera and receiver to the same channels
between CH1 – CH 4
Electrical Outlet
Coaxial Cable (75 ohm)
7
Television
Audio Video