Check Tire Pressures; Mowing Height Adjustment - Briggs & Stratton Snapper Pro S800X Series Operator's Manual

Operation

Check Tire Pressures

Tire pressure should be checked periodically, and
maintained at the levels shown in the chart. Note that these
pressures may differ slightly from the "Max Inflation"
stamped on the side-wall of the tires. The pressures shown
provide proper traction, improve cut quality, and extend tire
life.
Tire
Deck Caster Tires
Drive Tires
Tractor Caster Tires

Mowing Height Adjustment

The cutting height adjustment pin (A, Figure 4) controls
the mower cutting height. The cutting height is adjustable
between 1-1/2" (3,37 cm) and 5" (12,7 cm) in 1/4" (0,64
cm) increments.
1. Turn the ignition key (C) to the RUN position.
2. Press the mower deck lift actuator switch (B) foward
(away from the operator) to remove the pressure from
the deck height adjustment pin.
3. Place the deck height adjustment pin in the desired
location.
4. Press the mower deck lift actuator switch backwards
(towards the operator) until contact is made with the
deck height adjustment pin. Continue to retract the
actuator until the operating position indicator lamp (D)
stops flashing and shuts off.
NOTE: The actuator MUST be positioned correctly before
attempting to move the ground speed control levers out of
their NEUTRAL positions. If the actuator is not positioned
as described in the above step the mower's safety
interlock system will cause the engine to shut off.
18 18
Pressure
25 psi (1,03 bar)
Figure 3. Checking Tire Pressure
10 psi (0,69 bar)
25 psi (1,03 bar)
Figure 4. Mowing Height Adjustment
A. Cutting Height Adjustment Pin
B. Actuator Deck Height Toggle Switch
C. Ignition Switch Key
D. Operating Position Indicator Lamp
D
B
A
C
www.SnapperPro.com www.SnapperPro.com