Extreme Networks ExtremeRouting SLX 9640 Installation Manual page 44

Flush-front mounting
5. Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lb (17 cm-kg).
a. Bracket extension
b. Screws, 8-32 x 5/16-in., flathead Phillips
Figure 20: Attaching the bracket extensions to the device
Installing the device in the rack
Complete the following steps to install the device in the rack.
1. Position the device in the rack, as shown in
until the rail kit is secured to the rack.
2. Attach the right front bracket to the right front rack post using two 10-32 x 5/8-in. panhead screws
and two retainer nuts. Use the upper and lower holes in the bracket.
3. Attach the left front bracket to the left front rack post using two 10-32 x 5/8-in. panhead screws and
two retainer nuts. Use the upper and lower holes in the bracket.
44 ExtremeRouting SLX 9640 Hardware Installation Guide
Figure 21, providing temporary support under the device
Mounting the Device