Table of Contents
Advertisement
Service and maintenance
6.4 Replacing the device
Hot, toxic or corrosive process media
Risk of injury during maintenance work.
When working on the process connection, hot, toxic or corrosive process media could be
released.
● As long as the device is under pressure, do not loosen process connections and do not
● Before opening or removing the device ensure that process media cannot be released.
Improper connection after maintenance
Risk of explosion in areas subject to explosion hazard.
● Connect the device correctly after maintenance.
● Close the device after maintenance work.
Refer to Power (Page 41).
6.4
Replacing the device
Corrosive substances
Risk of chemical burns when replacing the sensor.
The sensor in the device contains corrosive substances that result in burns on unprotected
skin.
● Make sure that the sensor enclosure is not damaged when replacing the sensor.
● If contact with the corrosive substances occurs, rinse the affected skin immediately with
38
WARNING
remove any parts that are pressurized.
WARNING
CAUTION
large amount of water to dilute substance.
Compact Operating Instructions, 05/2020, A5E39942309-AB
SITRANS FC410
Advertisement
Table of Contents
