Joining Instruction - Hussmann BEXDWG Installation & Operation Manual

I
1-4
nstallatIon
Leveling Wall Merchandisers
Level the case by all four corners. Start at the
rear by placing the provided shims as needed
under each end of the rear base rail. The shims
are long enough to allow adjoining wall cases
to be leveled with the same shim. When the
rear of the case is level end-to-end, move to the
front of the case. Use shims as needed at each
front corner so that the front is also level from
end-to-end and front-to-rear.
Remove Bolts from Front
The merchandiser should be solidly supported
at least every 4 feet (1220 mm). Once the
merchandiser is level, if any gaps are present
under the base rail, shims should be inserted
approximately in line with the center front
support legs to support the rear of the case.
At the front of the case, insert shims under
each of the center legs so that they support the
front of the merchandiser.
Leveling Island or End Merchandisers
Position the first merchandiser at the highest
point. Set a long level (4 ft [1220 mm] or more)
on top of the discharge air flue. Insert shims until
the merchandiser is level from end to end and
from front to back.
NOTE: To avoid removing concrete flooring,
begin lineup leveling from the highest point of
the store floor.
P/N 3093114_A
JOINING INSTRUCTIONS
Sectional construction means that two or more
merchandisers may be joined in line yielding
one long continuous display requiring only
one pair of ends.
a
formaTion of ice or condensaTion
Prep Merchandiser
1. Check to be sure that merchandisers are
level. Locate Joining Kit and check contents.
2. Remove wire racks and display pan.
Before removing interior front and back
panels, remove the fasteners holding the
retainers for the discharge air louvers.
(Lift louvers up and out from the bottom.)
Remove any return air flue plex-glass parts.
(Lift up on interior panels to remove.)
Apply Gaskets to Right End
1. Apply the 1
the perimeter of the merchandiser as shown.
It must be at the edge. Check to be sure
that there are no gaps between gasket and
merchandiser.
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM
ll joinTs musT be airTighT To prevenT
/
5 in. (41 mm) gasket around
8
.