Joining Preparation - Hussmann Q3-M/FV-EP User Manual

Installation (cont'd)
Setting and Joining
The sectional construction of these models en-
able them to be joined in line to give the effect of
one continuous display.
An Alignment pin kit is supplied with every case
and must be used in alignment.
Leveling
IMPORTANT! IT IS IMPERATIVE THAT CASES
BE LEVELED FROM FRONT TO BACK AND
SIDE TO SIDE PRIOR TO JOINING. A LEVEL
CASE IS NECESSARY TO INSURE PROPER
OPERATION, WATER DRAINAGE, GLASS
ALIGNMENT AND OPERATION OF THE HING-
ES SUPPORTING THE GLASS. LEVELING
THE CASE CORRECTLY WILL SOLVE MOST
HINGE OPERATION PROBLEMS.
CASE BOLTING
LOCATION
ALIGNMENT
PLEXI PLATE
15
1. Using case blueprints, measure off and mark
on the floor the exact dimensions of where the
cases will sit. Snap chalk line for front and back
positions of base rail or pedestal. Mark the loca-
tion of each joint front and back. Find the high-
est point throughout the lineup. FLOORS ARE
NORMALLY NOT LEVEL! Determine the highest
point of the floor; cases will be set off this point.
All cases in the entire lineup must be brought up
to the highest level of the case sitting at the high-
est point in the lineup.
2. Set first case over the highest part of the floor
and adjust base so that case is level by using
shims.
CASE BOLTING
LOCATION
ALIGNMENT
PIN
ALIGNMENT PIN
LOCATION