Honeywell HUS-NVR-1032/6032-E User Manual page 27

3. Time zone, date and time can be set on the above tab. Click Next to go to the "Network"
tab as shown in the following figure:
Figure 4-6 Obtain an IP address automatically
4. You can set IP address for the NVR on this tab.
If select "Use the following IP address for LAN 1", you should manually set "IP Address",
"Subnet Mask" and "Gateway" respectively as shown in the following figure (the below
figure will change based on your DHCP settings):
Figure 4-7 Set the IP address manually
19