Bose BUILT-INvisible TA-1 Service Manual page 71

Setting the speaker configuration DIP switches (continued)
Important: Be sure to select the right settings for the speaker configuration you are using from
the table below. If an error is made, the speakers will have the wrong equalization and will not
sound right when played.
Configuration Left & Right
Unconfigured None
1 Jewel Cube
speaker
2 Jewel Cube
speaker
3 CS-2 cube
speaker array
4 CS-2 cube
speaker array
5 CS-2 cube
speaker array
6 131
speaker
7 131-R
speaker
*102 series speakers include the 102SE, the 131-R and the Model 32-R.
After setting the speaker configuration, changing it will cause the SETUP LED to flash continu-
ally to indicate that the current EQ does not match the switch settings. To set the EQ to the new
switch settings and stop the flashing, cycle the AC power to the TA-1 amplifier.
Appendix
Center
None
® Jewel Cube
speaker
Jewel Cube
speaker
CS-2 cube
speaker array
CS-2 cube
speaker array
VCS-10
speaker
® -R 131-R
speaker
VCS-10
speaker
Table 1. Satellite Speaker EQ DIP Switch Settings
Surround
None
Jewel Cube
speaker
102
speaker
CS-2 cube
speaker array
102 series
speaker
® CS-2 cube
speaker array
102 series
speaker
102 series
speaker
71
Settings
® series*