Table of Contents
Advertisement
Mounting the AP
The AP can be installed only indoors. You can mount the AP on a wall or a ceiling.
Mounting the AP on a wall
1.
Place the mounting bracket against the wall and mark the installation holes on the wall.
Figure 2-2 Marking the installation holes on the wall
2.
Drill holes with a diameter of 6 mm (0.24 in) and a depth of 30 mm (1.18 in) at the marked
locations, as shown in
Figure 2-3 Drilling holes in the wall
3.
Insert a screw anchor into each hole, and tap the screw anchor with a rubber hammer until it is
all flush with the wall surface, as shown in
Figure 2-4 Hammering the screw anchor into the wall
Figure
2-3.
Figure
2-2
2-4.
Advertisement
Table of Contents
