Omron HEM-9200T Instruction Manual page 13

4. Connect the device to the Telehealth service receiver.
As soon as insert batteries, it will automatically start the connection process,
as below.
When the display shown above is not appeared, see "Connecting
failure." in section 4.2 first.
To retry connecting the Telehealth service receiver, remove batteries
and press START/STOP button for 2-3 times. Then start with step 2
again.
Note: If your Telehealth service receiver asks for PIN code, enter 6 digits of
PIN code on the rating label at the bottom of the device to complete.
13