Table of Contents
Advertisement
Setting the programmed Vapor Clean
cycle
It is possible to program the vapor clean
start time, like any cooking function.
1. After selecting the vapor clean special
function, press the control knob. The
display shows the current time and the
symbol
comes on.
2. Turn the control knob to set the time you
wish the vapor clean cycle to finish.
3. After a few seconds, the symbols
and
remain lit steadily and the
appliance waits for the set start time in
order to start the cleaning cycle.
Cleaning and maintenance
End of the Vapor Clean cycle
1. Open the door and wipe away the less
stubborn dirt with a microfibre cloth.
2. Use an anti-scratch sponge with brass
filaments on tougher encrustations.
3. In case of grease residues use specific
oven cleaning products.
4. Remove any remaining water from the
oven.
For greater hygiene and to avoid food
being affected by any unpleasant odours,
we recommend that the oven is dried using
a fan-assisted function at 160°C for
approximately 10 minutes.
We recommend wearing rubber
gloves for these operations.
For easier manual cleaning of
parts that are difficult to reach, we
recommend removing the door.
135
Advertisement
Table of Contents
