Status; Test; Configuration (Config); Dial - ADTRAN DSU III ARdc Manual

Chapter 3. Operation

Status

S is used to display all relevant information for the network and
TATUS
DTE interfaces. It displays the current operating mode, loop status, rate of
service from the network, DTE data rate and format, and DTE interface
lead status. The display returns to the status menu when the front panel
is not accessed. Refer to Status Selection on page 12-1 for more detailed in-
formation.

Test

T is used to control local and remote testing. Select L
EST
testing, and select the type of test and test pattern when required. For
more information see Testing and Troubleshooting on page 11-1 .

Configuration (CONFIG)

C
ONFIGURATION
to configure testing and dialing options, and to enter a manual command.
This menu branch is divided into several chapters for easier reference. The
division includes a brief overview chapter followed by a separate chapter
for each of the five sub-menus of the C
Options on page 5-1, Configuring DTE Options on page 6-1, Configuring Test
Options on page 7-1, Configuring Dial Options on page 8-1, and Manual Com-
mand on page 9-1.

Dial

D provides manual dialing functions. Key in a number to dial, select
IAL
one of the ten stored numbers, or redial the last dialed number. This menu
is available for use only when AT&T/MCI SW56 or US SPRINT SW56 is
the selected network type. See Dial Selection on page 10-1 for more infor-
mation.
3-2
is used to select network and DTE operating parameters,
DSU III ARdc User Manual
branch: Configuring Network
ONFIG
or R
OCAL EMOTE
61200270L1-20