Sony HKCU-IP43F Operation Manual page 57

NETWORK
Page name Item
Page No.
<NETWORK GENLOCK> PORT
N05
NETWORK
(When HKCU-4001 is
GENLOCK
installed)
PROFILE
PTP MASTER INFO
LOCK STATUS
<PTP STATUS> PTP PORT
N06
PORT SEL
(When HKCU-4001 is
installed)
Network Status
Set value
LAN1, LAN2
DISABLE, ENABLE
ST2059-2
DOMAIN 0 to 127, 127
NUMBER
COMMUNICATION MULTICAST MODE, MIXED
MODE MODE
DELAY –7 to –1
REQUEST
INTERVAL
IP ADDRESS 0.0.0.0 to 255.255.255.255
SYNC INTERVAL –7 to –1
PRIORITY 1 0 to 255
PRIORITY 2 0 to 255
STEP ONE-STEP, TWO-STEP
NOT IN USE,
NO MASTER,
LOCKING,
LOCKED
LAN1, LAN2
LAN1, LAN2
Time
GMClockID
MasterID
Sync
FollowUp
DelayReq
DelayResp
NOT GOOD, GOOD,
VERY GOOD
Delay
Jitter
Description
Selects the port of the HKCU-4001 for setting
NETWORK GENLOCK.
Enables/disables network genlock for the selected
port.
Displays the supported profile. Only ST2059-2 profile
is supported.
Sets the domain number.
Note
Set to the domain number of the master device to be
connected.
MULTICAST MODE: Multicast reply to the master.
MIXED MODE: Unicast reply to the master.
Displays the delay of the response to the PTP
master.
Displays information obtained from the PTP master.
Displays the IP address of the currently
synchronized PTP master device.
Displays the Sync Interval setting of the master
device.
Displays the priority of the PTP master. The lower
the number, the higher the priority.
Displays the mode in which the timestamp is sent.
ONE-STEP: Sent in Sync message.
TWO-STEP: Sent in Follow-up message.
Displays the PTP operation status.
NOT IN USE: PTP operation stopped
NO MASTER: PTP master is not found.
LOCKING: Synchronizing
LOCKED: Synchronized
Displays the port on which PTP is running, and the
status.
Selects the port for which to display the status.
Displays the PTP master time.
Grand master clock ID
Master clock ID
Sync message rate
Follow-up message rate
Delay request message rate
Delay response message rate
Displays the network status.
Displays the network delay.
Displays the network jitter.
57