To Use The Aw-3 - JUKI AW-3S Instruction Manual

3-6. To use the AW-3

When using the AW-3, the memory switch (level 2) "
to "enable".
No.
Enabled
Disabled (AW-3 is not installed)
Disabled (AW-3 is installed/with communication) *
Disabled (AW-3 is installed/no communication) *
* Select when the AW-3 is installed but not operated.
If the memory switch is set to "With communication", the version of AW-3 software can be
confirmed and rewritten.
When the memory switch is initialized, the AW-3 is disabled. Re-set the memory switch
" " to "enable".
[ How to change the memory switch (level 2) ]
A
<Mode changeover screen>
(1) Displaying the memory switch data (level 2) list screen
When switch is held pressed by approximately six seconds,
per section of screen.
A is pressed to display next page on the screen, memory switch (level 2)
When
displayed. When the button of
played.
" (AW-3 enable/disable setting) must be set
Description
B
<Mode changeover screen>
B is pressed, the memory switch (level 2) list screen is dis-
– 13 –
Initial value
Disabled
A is displayed on the up-
B is