Installing and connecting the device
3.2 Mounting the device
Procedure for mounting
Procedure for dismantling
1. Press the device down until the lower rail guide frees the device.
2. Swing the device out of the rails.
3. Remove the rail from the device.
3.2.3
Wall mounting
Wall mounting is one of the horizontal mounting types.
Requirements
• A screwdriver
• Four anchors and four M4 screws
24
Lay the standard rail bracket on the rear of the
device.
Fasten the standard rail bracket with 2 screws.
Place the device with the standard rail bracket
onto the mounting rail from above.
If the device is tilted when you place it down,
the standard rail bracket does not grip.
Press the device down and toward the standard
rail until the standard rail bracket engages.
Check whether the device is seated firmly on the
standard rail.
Operating Instructions, 09/2021, A5E51366275-AA
SIMATIC IPC327G