Overview
1.4 System components
1.4.3
Adapter set for support arm and stand mounting of PRO device
The PRO device can be mounted on systems from third-party vendors (see section "Mounting
the device (Page 28)"). For this you will need the Siemens base adapter (see Base adapter
(Page 14)) and a proprietary adapter set.
Siemens also offers its own adapter for VESA-compatible third-party systems:
Adapter set
SIEMENS:
•
•
RITTAL:
Adapter for
Siemens PRO-Panel
•
•
ROLEC:
Adapter for
Siemens PRO-Panel
•
•
BERNSTEIN:
Coupling for Siemens SIMATIC
PRO
•
•
Information provided without guarantee.
1.4.4
Extension Unit and operator controls
Extension components - Extension Unit
Note
When the IPC277G PRO is extended with an Extension Unit, the effect on the device
approvals for the entire system must be considered.
The Extension Unit is used to install additional operator controls under a SIMATIC PRO device
of the type "Suitable for extension components" with 16:9 display.
The example in the figure below shows the Extension Unit 22" with eight operator controls
including emergency stop button.
16
Adapter set VESA75
Adapter set VESA100
Intermediate plate
Screws
Intermediate plate
Screws
No intermediate plate
required
Coupling with integrated
adaptation for PRO device
Suitable for support arm systems Article number
•
VESA75-compatible systems
•
VESA100-compatible systems
•
CP40 steel
•
CP60/120 for
Support arm connection
120 × 65 mm
•
profiPlus-50
•
taraPLUS for ∅ 65 mm hole
circle
•
CS-3000
Operating Instructions, 02/2022, A5E51373692-AA
•
6AV7674-0KE00-0AA0
•
6AV7674-0KD00-0AA0
•
6206.500
•
142.024.000
•
1015300187 RAL 9006
white aluminum
•
1015300043 RAL 7016
anthracite gray
SIMATIC IPC277G PRO