Wall Mounting - Siemens SIMATIC IPC427E Operating Instructions Manual

Procedure
Installation
1. Place the device and rail clip on the upper
edge of the standard profile rail at the
position shown.
2. Push down the device. Once the rail clip is
over the bottom edge of the standard
profile rail, push the device towards the
standard profile rail. You will hear the
device click into place.
Removal
1. Push down the device until it is released by the rail clips.
2. Swing the device out of the standard profile rail.
3. Lift the device up and off.
3.2.3

Wall mounting

The fasteners and screws required are supplied with the device for the selected mounting
option (as specified in order number).
Requirement
• 2 mounting brackets
• 6 screws
• 1 T20 screwdriver
SIMATIC IPC427E
Operating Instructions, 02/2021, A5E37454814-AE
Installing and connecting the device
3.2 Installing the device
29