Table of Contents
Advertisement
CAUTION:
• The AC power cord provided with the PSR150-A1/PSR150-A2 power module uses a C13
connector. The AC power cord provided with the PSR360-56A/PSR720-56A/PSR1110-56A
power module uses a high-temperature C15 connector. Do not mix them.
• Provide a circuit breaker for each power module and make sure the circuit breaker is off before
installation.
Connecting the power cord for the built-in AC power module
(1)
The following procedure applies to the S5560X-34S-EI and S5560X-54S-EI switches.
To connect the power cord for the built-in AC power module:
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Attach two ends of the bail latch into the holes on the two sides of the AC power receptacle, and
pull the bail latch upwards (see Figure2-30).
3.
Connect the female connector of the AC power cord to the AC-input power receptacle on the
power module (see callout 1 in Figure2-31).
4.
Pull the bail latch down to secure the connector to the AC-input power receptacle (see callout 2
in Figure2-31).
5.
Connect the other end of the power cord to an AC power source.
Figure2-30 Connecting the power cord for the built-in AC power module (1)
Figure2-31 Connecting the power cord for the built-in AC power module (2)
2
1
2-25
Advertisement
Table of Contents
