Table of Contents
Advertisement
4.
Tighten the screws on the connector with a flat-blade screwdriver to secure the connector in the
DC-input power receptacle (see callout 2 in Figure2-37).
5.
Connect the two wires at the other end of the power cord to a –48 VDC power source or an
RPS.
Figure2-37 Connecting the PSR150-D1
Figure2-38 Connecting the PSR560-56D
Connecting the PSR360-56A/PSR720-56A/PSR1110-56A
The power cord connection procedure is the same for the PSR360-56A, PSR720-56A, and
PSR1110-56A power modules. The following procedure uses the PSR720-56A power module as an
example.
To connect the PSR720-56A:
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Plug the female connector end of the AC power cord into the AC-input power receptacle of the
power module (see callout 1 in Figure2-39).
3.
Use a cable tie to secure the power cord to the handle of the power module (see callout 2 and
callout 3 in Figure2-39).
4.
Connect the other end of the AC power cord to an AC power source.
1
1
2
2
2-29
Advertisement
Table of Contents
