Table of Contents
Advertisement
Project Planning Manual | Rexroth IndraControl VDP 92.3
Note for the Machine Manufacturer
4.4.3
UL/CSA Certified
4.5
Wear Parts
Backlight
Standard
Title
DIN EN
Electromagnetic compatibility (EMC)
61000-6-4
Volume: 6-4: Generic standards - Immunity for in‐
(VDE 0839-6-4)
dustrial environments (IEC 61000-6-4:2006)
DIN EN
Electromagnetic compatibility (EMC)
61000-6-2
Volume: 6-2: Generic standards - emitted interfer‐
(VDE 0839-6-2)
ence for industrial environments (IEC
61000-6-2:2005)
Fig.4-4:
Electromagnetic compatibility (EMC) standards
The electronic products described in this project planning manual do not fall
under the machines listed in the EC guidelines. Therefore, explanations are not
required for the 89/392/EMC guideline and do not exist.
89/392/EMC, the EC guideline for machines, specifies the requirements on a
machine. In this guideline, a machine is defined as a combination of the com‐
ponents or mechanisms combined with each other. The described products
belong to the electrical equipment of a machine. Therefore, they are to be in‐
cluded in the declaration of conformity of the machine manufacturer.
The standard EN 60204-1 (safety of machinery, general requirements on the
electrical equipment of the machines) can be used for the electrical equipment
of the machines.
The CE marking is only valid for the device in its delivery status (ex
works). After modifying the device, e.g. after plugging additional
extension cards, CE compliance must be checked.
The devices of the IndraControl VDP 92.3 family are certificated according to
●
UL508 (Industrial Control Equipment) and
●
C22.2 no. 142-M1987 (CSA)
UL file no. E210730
But there can be combination or extension stages with limited or missing cer‐
tification. Thus, the registration is to be verified according to the UL marking on
the device.
The UL/CSA marking is only valid for the device in its delivery status
(ex works). After modifying the device, e.g. after plugging additional
extension cards, UL compliance must be checked.
The wear parts as well as their service life are described in this section. Wear
parts are not subject to any warranty.
●
The backlight has a limited service life. When the service time was ex‐
ceeded, the backlight produces only 50 % of its original brightness. This
time differs for the used displays:
Electric Drives
| Bosch Rexroth AG
and Controls
17/52
Technical Data
Edition
September
2007
March 2006
Advertisement
Table of Contents
