Cleaning The Engine Screen And The Oil Cooler; Fuel System Maintenance; Servicing The Carbon Canister - Toro Pro Force Debris Operator's Manual

Note:
if the air gap is not correct, bend the side
electrode to adjust the air gap.
7. Thread the spark plug into the engine, and
torque the plug to 27 N∙m (20 ft-lb).
8. Repeat steps 2 through
Cleaning the Engine Screen
and the Oil Cooler
Service Interval: Before each use or daily
Before each use, check and clean the engine screen
and oil cooler. Remove any build up of grass, dirt or
other debris from the oil cooler and engine screen
(Figure 37).
Figure 37
1. Engine screen
2. Oil cooler
6 at the other cylinder.
g002355
Fuel System
Maintenance
Servicing the Carbon
Canister
Replacing the Carbon Canister Air
Filter
Service Interval: Every 200 hours
1. Prepare the machine for maintenance; refer to
Preparing for Machine (page
2. Remove and discard the carbon canister air
filter (Figure 38).
1. Carbon canister
3. Install the new air filter.
Replacing the Carbon Canister
Purge-line Filter
Service Interval: Every 200 hours
Note:
Check the purge-line filter occasionally for dirt.
If the filter appears to be dirty, replace it.
1. Prepare the machine for maintenance; refer to
Preparing for Machine (page
30
25).
Figure 38
2. Carbon canister air filter
25).
g029820