Table of Contents
Advertisement
2 0 0 / 6 0 0 H o u r S e r v i c e
Use Reverb Vise Blocks to prevent damage to the seatpost or any seatpost components when clamping into a vise. Clamp each component only
tight enough to prevent it from spinning or slipping in the vise blocks. Clean the vise blocks with isopropyl alcohol and a clean shop towel before
use.
Do not attempt to disassemble the Reverb AXS XPLR seatpost electronics compartment assembly. Disassembly may cause permanent damage to
electronic components.
1
Secure the bicycle in an upright position.
Secure the bicycle in an upright position.
The seatpost will be removed from the bicycle. Do not clamp the
The seatpost will be removed from the bicycle. Do not clamp the
seatpost in a bicycle work stand before removal.
seatpost in a bicycle work stand before removal.
2
P P ress and hold the assigned AXS handlebar controller paddle, AXS
road shifter paddles, or Blip to fully extend the seatpost.
3
Open the battery latch and remove the SRAM battery.
Open the battery latch and remove the SRAM battery.
S e a t p o s t R e m o v a l
to fully extend the seatpost.
N OT ICE
AXS Controller
AXS BlipBox and Blip
AXS Road Shifters
12
Seatpost Removal
Advertisement
Table of Contents
