SRAM Rockshox Reverb AXS XPLR 2022 Service Manual page 39

Table of Contents

Advertisement

4
Push the upper post up until it stops. The air piston should be just
Push the upper post up until it stops. The air piston should be just
below the lower post inner threads.
below the lower post inner threads.
5
Thread the air piston into the upper post/seatpost head while holding
the seatpost head to prevent it from being pushed down.
Note: When the air piston is tightened, the other end of the air shaft will
also be tightened to the correct torque onto the seatpost head inside
the upper post.
Do not over-tighten the air piston. Over-tightening can damage the
air piston, air shaft, and seatpost head.
6
Apply a light coat of grease to the entire length of the poppet valve
shaft.
NOTI CE
10 mm
SRAM Butter Grease
10 mm
3.5 N•m (31 in-lb)
39
Air Assembly Installation

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rockshox reverb axs sp-rvb-xplr-a1

Table of Contents