Mounting the Enclosure
Use a maximum of a #10 screw to fit properly in the diameter of the mounting holes (see
Figure
12). Make sure to leave a minimum clearance of 2 inches from the hinges for opening
the door. Complete the following steps to mount the enclosure:
1. Using the enclosure as a template and a carpenter's level, mark the locations for the three
mounting holes on the mounting surface.
2. Pre-drill the marked locations and install fasteners or anchors appropriate to the
mounting surface and the weight of the ONT (approximately 5 pounds).
3. Mount the ONT to the side of the subscriber's premises.
61187602G2-5A
Figure 12. Outer Enclosure Mounting Holes
Mounting Holes
Installation
23