Total Access 362R Single Family Unit with RF Return Installation and Maintenance Guide
Mounting the Enclosure
Use a maximum of a #10 screw to fit properly in the diameter of the mounting holes (see
Figure 8). Make sure to leave a minimum clearance of 2 inches (50 mm) from the hinges for
opening the door. Complete the following steps to mount the enclosure:
1. Using the enclosure as a template and a carpenter's level, mark the locations for the two
2. Pre‐drill the marked locations and install fasteners or anchors appropriate to the
3. Mount the ONT to the side of the subscriber premises.
20
mounting holes on the mounting surface. (For an indoor mount, prepare the mounting
surface by attaching a 3/4 inch (19 mm) plywood board to the wall studs. This provides
long‐term stability for the SFU ONT.)
mounting surface and the weight of the ONT (each anchor rated to 15 lbs minimum, or
6.8 kg) and the weight of the SFU ONT (approximately 3.8 pounds, or 1.7 kg).
Splice Housing
Figure 8. Enclosure Mounting Holes
Surface Mounting Holes
Surface Mounting Holes
OptiTap Housing
61187715G1-5B