Figure 2-2 Appearance Of The Module (Without Label); Table 2-1 Definitions Of Pins On The Lga Interface - Samsung SA-N9001 Hardware Manual

Figure 2-2 Appearance of the module (Without Label)

Table 2-1 Definitions of pins on the LGA interface

No Name
POWER
F15 VDD_1P8_AP
Q32 VPH_PWR
Q34 VPH_PWR
R33 VPH_PWR
P13 VLDO2_CP_VDD180
R21 VLDO10_CP_USIM0
R17 VLDO11_CP_USIM1
Antenna Port
C2 MAIN_ANT
Q2 DIV_ANT
G2 GNSS_ANT_L1
E2 GNSS_ANT_L5
Antenna switching
M8 RFFE_DATA
N9 RFFE_CLK
E12 GPADC2
PCIE Interface
© SAMSUNG Electronics Co., Ltd. Confidential & Proprietary
TOP VIEW
The position of the 1st pin where the triangle mark is located.
Internal
Voltage
I/O Pull
Level
state
Power
1.8 -
Input
4.0 ~ Power
-
4.4 Input
4.0 ~ Power
-
4.4 Input
4.0 ~ Power
-
4.4 Input
Power
1.8 -
Output
Power
1.8 -
Output
Power
1.8 -
Output
- - -
- - -
- - -
- - -
1.8 O -
1.8 O -
1.8 I -
BOTTOM VIEW
Connection to TCU
Description
(BMW WAVE)
VDD AP Power /
Input for PCIe PU
NAD Main POWER
(4.2V~4.5V)
VDD CP Power /
NAD_ECP_1V8
Output
USIM0 Power
NAD_SIM0_VCC
output
Leave this pin
Reserved
open(floating)
Prx(MiMo #1)
Cellular_MainAnt1
Antenna Port
Drx(MiMo #2)
Cellular_MainAnt2
Antenna Port
Leave this pin
GNSS L1 ANT
open(floating)
Leave this pin
GNSS L5 ANT
open(floating)
MIPI DATA for ANT
switch at TCU side
MIPI CLK for ANT
switch at TCU side
Connect to GND if
Ant switch (ADC)
unused
Connection to TCU
External AP
(VOLVO TCAM2)
UG1V8_NAD UG1V8_NAD
UG4V2
UG4V2
UG4V2
NAD_ECP_1V8
NAD_SIM0_VCC
NAD_SIM1_VCC
Cellular_MainAnt1
Cellular_MainAnt2
GNSS_ANT_L1
GNSS_ANT_L5
Ant switch
Ant switch
Ant switch (ADC)
eAP
UG4V2
UG4V2
UG4V2
Ant switch
Ant switch
17 / 79