8.4 Adjusting the air flow direction
8.4.1 About the air flow flap
RXYQQ8~20U7Y1B
VRV IV Q+ series heat pump
4P546229-1A – 2020.10
1
1
2 Press the operation mode selector button on the user interface several times
and select
(program dry operation).
3 Press the ON/OFF button of the user interface.
Result: The operation lamp lights up and the system starts operating.
4 Press the air flow direction adjust button (only for double-flow, multi-flow,
corner, ceiling-suspended and wall-mounted). Refer to
4
flow
direction" [
31] for details.
To stop
5 Press the ON/OFF button on the user interface once again.
Result: The operation lamp goes out and the system stops operating.
NOTICE
Do not turn off power immediately after the unit stops, but wait for at least 5
minutes.
Refer to the operation manual of the user interface.
For the following conditions, a micro computer controls the air flow direction
which may be different from the display.
Cooling
▪
When the room temperature is lower
than the set temperature.
Double flow+multi-flow units
Corner units
Ceiling suspended units
Wall-mounted units
▪
When starting operation.
▪
When the room temperature is higher
than the set temperature.
▪
At defrost operation.
8
Operation
|
"8.4 Adjusting the air
Heating
Installer and user reference guide
31