Siemens SINAMICS GL150 Operating Instructions & Installation Instructions page 21

The nominated person in control of an electrical installation must ensure that the following
points are observed:
● Follow the local and industry-specific safety and setup regulations. Observe the
● The operating instructions and the complete product documentation are always available
● The technical data as well as the specifications relating to the permissible installation,
● Only qualified personnel or personnel supervised by responsible, skilled specialists are
● During shipping, specific transport conditions are adhered to.
● Assembly is performed according to assembly instructions. Separate cabinet units are
● All instructions for EMC-compatible installation, cabling, shielding, grounding, and for
● Commissioning is only to be performed by qualified personnel trained for that purpose in
● System configuration is carried out by an experienced system integrator. Additional system
● The device is only operated in conjunction with the engineered components.
● Different operating modes, overloads, load cycles, and differing environmental conditions
Make use of the support and services offered by the relevant service center for planning,
installation, commissioning, and servicing work. You can find the relevant contact person under
"Service & Support (Page 133)".
See also
Standards and regulations (Page 135)
SINAMICS GL150 6SL38502UM114PA0Z
Operating Instructions Rev.201910281441 EXAMPLE
2.7 Information for nominated persons in control of an electrical installation
requirements in the guidelines specified in the "Standards and regulations" section of the
"Technical data and drawings." Ensure that the specific safety and construction regulations
and the regulations for using personal protective equipment are observed during all work.
when carrying out any work.
connection, ambient and operating conditions are taken into account at all times.
allowed to carry out basic planning and all work on the device.
connected properly (cables and busbars).
adequate auxiliary power supply are to be observed.
accordance with the commissioning instructions.
components - such as circuit-breaker, transformer, cables and motor - are coordinated and
harmonized with one another for converter operation.
are permitted only after special arrangement with the manufacturer.
Safety information
21