Omron E5 K Series Manual page 10

E5AK/E5CK/E5EK
J PARAMETERS DEFINITIONS
Refer to your User's Manual for each parameter and the calibration mode in detail.
Level 0 Mode for E5AK and E5EK
1 3 0 0
0
s p - m
0
o
50.0
c - o
50.0
r - 5
run
Level 0 Mode for E5CK
PV/SV
1 3 0 0
The process value is displayed on the No.1 display and the set point is displayed on the No.2 display.
0
When the multi-SP function is in use, the value of the current set point (SP0 or SP1 is displayed).
Set Point During SP Ramp
s p - m
Monitors the set point when the SP ramp function is used.
0
Manipulated Variable (MV) Monitor for Heat
o
Monitors the manipulated variable (MV) for the heating output.
50.0
Manipulated Variable (MV) Monitor for Cool
c - o
When the Controller is in heating and cooling control operation, use this display to monitor the manipulated
50.0 variable of the cooling output.
Run/Stop
r - 5
Places the controller in RUN mode or in STOP mode.
run
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
PV/SV
The process value is displayed on the No.1 display and the set point is displayed
on the No.2 display. When the multi-SP function is in use, the value of the current
set point (SP0 or SPD is displayed).
Set Point During SP Ramp
Monitors the set point when the SP ramp function is used.
For E5VK-
Manipulated Variable (MV) Monitor for Heat
PRR2
Monitors the manipulated variable (MV) for the heating output.
U-m
Valve Opening Monitor
100
Displays the valve position in percentage format.
Open = 100%
Closed = 0%
Manipulated Variable (MV) Monitor for Cool
When the Controller is in heating and cooling control operation, use this
display to monitor the manipulated variable of the cooling output.
Run/Stop
Places the controller in RUN mode or in STOP mode.
E5AK/E5CK/E5EK
101