Messages List - Sony ICD-TX50 Operating Instructions Manual

Ic recorder
Hide thumbs Also See for ICD-TX50:
Table of Contents

Advertisement

11
11
Troubleshooting

Messages List

Follow the instructions below if a message appears in the display.
Message
HOLD...
Slide HOLD Switch to
Activate.
Low Battery Level
Low Battery
Low Battery to Update
microSD Card Error
microSD Card Not
Supported
Read Only microSD Card  A read‑only microSD card is inserted. A read‑only
microSD Card Locked
Memory Full
File Full
Settings are Full
Track Marks are Full
File Damaged
Cause/Remedy
 All the button operations are disabled because the IC
recorder is in the HOLD status to prevent unintentional
operations. Slide the POWER•HOLD switch towards the
center to release the IC recorder from the HOLD status
(  p. 16).
 You cannot format the memory or erase all the files in a
folder because of insufficient battery power. Charge the
battery (  p. 18).
 The battery is exhausted. Charge the battery (  p. 18).
 You cannot update the firmware because of insufficient
battery power. Charge the battery (  p. 18).
 An error occurred while a microSD card was being inserted
into the microSD card slot. Remove and try inserting it
again. If this message persists, use a new microSD card.
 A microSD card that the IC recorder does not support is
inserted. See "About compatible microSD cards" (  p. 33).
microSD card cannot be used with the IC recorder.
 A write‑protected microSD card is inserted. Release the
lock.
 The remaining memory capacity of the IC recorder is
insufficient. Erase some files before recording.
 When there are already the maximum number of files in
the selected folder or the total number of files stored on the
IC recorder has exceeded the maximum, you cannot record
a new file. Erase some files before recording.
 You cannot rename a folder, since folders with the same
folder name already exist. Please select a different folder
name.
 You cannot set a track mark, since there are already the
maximum number of track marks for a file. Cancel
unwanted track marks (  p. 61).
 You cannot play back or edit files, because the data of the
selected file is damaged.
Continued 

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents