Samsung NX58 565 Series User Manual page 75

PROBLEM POSSIBLE CAUSE
The oven You have a function error
control beeps code. See the Troubleshooting
and information codes chart
and displays
an error code. on page 80.
All burners do The power cord is not
plugged into the electrical
not light.
outlet.
A fuse in your home may be
blown or the circuit breaker
tripped.
The gas supply is not properly
connected or turned on.
Surface The control knob is not set
burners do not properly.
light.
The burner caps are not in
place.
The burner base is misaligned.
NX58H5 Series_AA_DG68-00526A-14_EN+MES+CFR_WEB.indb 75
SOLUTION
Press the OFF/CLEAR pad Surface burner
and restart the oven. If the clicks during
problem persists, disconnect
operation.
all power to the range for at
least 30 seconds and then
reconnect the power. If this
The burners
does not solve the problem,
do not burn
call for service.
evenly.
Make sure the electrical
plug is plugged into a live,
properly grounded outlet.
Replace the fuse or reset the
Very large or
circuit breaker.
yellow surface
burner flames.
See the Installation
Instructions that came with
your range.
Surface
Push in the control knob and
burners light
turn it to the LITE position.
but oven
Clean the electrodes.
burners do not
Put the burner cap on the light.
burner head. Align the burner
base.
PROBLEM POSSIBLE CAUSE
The control knob has been left
in the LITE position.
Surface burner components
and caps are not assembled
correctly and level.
Surface burners are dirty.
Wrong orifice is assembled.
The oven door lock is turned
on.
Gas Pressure Regulator
shut off switch is in the 'off
position.
SOLUTION
After the burner lights, turn
the control knob to a desired
setting.
If the burner still clicks,
contact a service technician.
See page 64.
Clean surface burner
components. (See pages 64
and 65.)
Contact your installer. Check
the burner orifice size and
contact your installer if you
have the wrong orifice. Check
the LP gas conversion.
The display will show the
Lock icon. Hold the oven door
open and press the START/
SET pad for 3 seconds. The
oven will beep and the Lock
icon will turn off.
Call a qualified service
technician.
English 75
2020-06-23 오전 9:09:54