Technical Specifications - Metabo PowerMaxx BS 12 Original Instructions Manual

en ENGLISH
recycling of disused tools, packaging and
accessories.
Battery packs may not be disposed of with regular
waste. Return faulty or used battery packs to your
Metabo dealer!
Do not allow battery packs to come into contact with
water!
Protect the environment, and do not dispose
of power tools and battery packs with house-
hold waste. Observe national regulations on
separated collection and recycling of disused
machines, packaging and accessories.
Discharge the battery pack in the power tool before
disposal. Prevent the contacts from short-circuiting
(e.g. by protecting them with adhesive tape).

10. Technical Specifications

Explanatory notes on the specifications on page 4.
Subject to change in accordance with technical
progress.
U = voltage
(max. voltage = 12 V,
nominal voltage = 10.8 V)
n = No-load speed
0
Tightening torque for screwing:
M = soft screwing application (wood)
A
M = hard screwing application (metal)
B
M = adjustable torque (with torque control)
C
Max. drill diameter:
D = in steel
1 max
D = in softwood
2 max
D = in masonry
3 max
s = max. impact rate
m = Weight (with the smallest battery pack)
G = Spindle thread
Measured values determined in conformity with
EN 62841.
Permitted ambient temperature during operation:
-20 °C to 50 °C (limited performance with
temperatures below 0 °C). Permitted ambient
temperature for storage: 0 °C to 30 °C
direct current
The technical specifications quoted are subject to
tolerances (in compliance with relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. The actual load may be higher
or lower depending on operating conditions, the
condition of the power tool or the accessories used.
Please allow for breaks and periods when the load
is lower for assessment purposes. Arrange
protective measures for the user, such as
organisational measures based on the adjusted
estimates.
Vibration total value (vector sum of three directions)
determined in accordance with EN 62841:
12
a = Vibration emission value
h, ID
(impact drilling in concrete)
a = Vibration emission value
h, D
(Drilling in metal)
a = Vibration emission value (screwing
h, S
without impact)
K = Uncertainty (vibration)
h, ...
Typical A-effective perceived sound levels:
L = Sound-pressure level
pa
L = Acoustic power level
WA
K , K = Uncertainty (noise level)
pA WA
During operation the noise level can exceed
80 dB(A).
Wear ear protectors!