Troubleshooting; Accessories; Repairs; Environmental Protection - Metabo PE 12-175 Instructions For Use Manual

ENGLISH
frequently and thoroughly. Here, the machine
must be held firmly.
The Autostop carbon brushes must be replaced in
a specialist workshop. Always have checks and
maintenance work carried out by Metabo
Customer Service.

12 Troubleshooting

Restart protection
If the mains plug is inserted with the machine
switched on, or if the current supply is restored
following an interruption, the machine does not
start up.
The red electronic signal indicator (6) starts
flashing.
Switch the machine off and then back on again.
The electronic signal indicator (6) lights up
and on-load speed is reduced.
Winding temperature too high. Run the machine
in idling until the electronics signal indicator
switches off.

13 Accessories

Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
For the dealer to select the correct accessory, he
needs to know the exact model designation of
your power tool.
See page 4:
a Polishing and sanding disc with velcro-type
fastening
b Foam polishing disc, coarse with velcro-type
fastening
c Foam polishing disc, fine with velcro-type
fastening
d Foam polishing disc, profiled with velcro-type
fastening
e Felt polishing disc, hard with velcro-type
fastening
f Felt polishing disc, soft with velcro-type
fastening
g Lambskin polishing disc with velcro-type
fastening
h Lambskin polishing disc with cord drive
i Sanding fleece with velcro-type fastening
j Adhesive intermediate disc with velcro-type
fastening
k Felt polishing disc with female thread M 14
l Buffing disc 200 x 20 mm
m Shank
12

14 Repairs

Repairs to electrical tools must be
carried out by qualified electricians
ONLY!
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please enclose a description of the fault with the
power tool.

15 Environmental Protection

Metabo's packaging can be 100% recycled. Worn
out power tools and accessories contain
considerable amounts of valuable raw and plastic
materials, which can be recycled.
These instructions are printed on chlorine-free
bleached paper.
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Guideline
2002/96/EC on used electronic and electric
equipment and its implementation in national
legal systems, used power tools must be collec-
ted separately and handed in for environmentally
compatible recycling.

16 Technical Specifications

Explanation of details on page 2. Subject to
changes serving technical progress.
D = maximum support plate diameter
max
n = No-load speed
* 1
0
n = Speed at rated load
*
1
N
P = Nominal power input
1
P = Power output
2
M = maximum torque
max
T = Spindle thread
m = Weight (without mains cable)
a = Typical estimated acceleration in the
hw
hand/arm area
Typical A-effective perceived sound levels:
L = Sound pressure level
pA
L = Acoustic power level
WA
K = Measurement uncertaincy
Wear ear muffs!
Values measured according to EN 60745.
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
* 1 Strong, high frequency interference can cause
speed fluctuations of up to 20%. However, such
fluctuations stop as soon as the interference
clears.