Environmental Protection; Technical Specifications - Metabo SXA 18 LTX 125 BL Original Instructions Manual

9. Accessories
Note: Metabo accessories are adapted to suit the
machine's hook and loop-type fastening. This
increases the service life of the hook and loop-type
fastening.
Use only original Metabo or CAS (Cordless Alliance
System) battery packs and accessories.
Battery packs marked with CAS are 100%
compatible with CAS devices (Cordless Alliance
System).
Use only accessories that fulfil the requirements
and specifications listed in these operating
instructions.
If you need any accessories, check with your
dealer.
A Battery packs with different capacities. Buy
battery packs only with voltage suitable for your
power tool.
12 V
Order no.: 625349000 4.0 Ah (LiHD)
18 V
Order no.: 625367000 4.0 Ah (LiHD)
etc.
B Chargers:
ASC 55, ASC 145
etc.
C Sleeve: fitting see chapter 6.4
Order no.: 635409000
for hose with diameter 32/35 mm
Order no.: 635401000
Sleeve with hose 27 mm fitted
Chargers are only suitable for charging Metabo and
CAS (Cordless Alliance System) battery packs.
For a complete range of accessories, see
www.metabo.com or the catalogue.
10. Repairs
Repairs to electrical tools must ONLY be
carried out by qualified electricians!
Contact your local Metabo representative if you
have Metabo power tools requiring repairs. For
addresses see www.metabo.com.
You can download a list of spare parts from
www.metabo.com.

11. Environmental Protection

Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Packaging materials must be disposed of according
to their labelling in accordance with municipal
guidelines. Further information can be found at
www.metabo.com in the "Service" section.
Only for EU countries: never dispose of
power tools in your household waste!
According to European Directive 2012/19/EU
on Waste from Electric and Electronic Equipment
and implementation in national law, used power
tools must be collected separately and recycled in
an environmentally-friendly manner.

12. Technical Specifications

Explanatory notes on the specifications on page 3.
Changes due to technological progress reserved.
D = Diameter of sanding plate
n = Idle speed (setting wheel)
0
s = Oscillating frequency at idle speed
0
(setting wheel)
S = Oscillating circuit diameter
m = Weight without battery pack
Measured values determined in conformity with EN
62841.
Permitted ambient temperature during operation:
-20 °C to 50 °C (limited performance with
temperatures below 0 °C). Permitted ambient
temperature for storage: 0 °C to 30 °C
direct current
The technical specifications quoted are subject to
tolerances (in compliance with relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. The actual load may be higher
or lower depending on operating conditions, the
condition of the power tool or the accessories used.
Please allow for breaks and periods when the load
is lower for assessment purposes. Arrange
protective measures for the user, such as
organisational measures based on the adjusted
estimates.
Vibration total value (vector sum of three directions)
determined in accordance with EN 62841:
a = Vibration emission value (surface
h
grinding)
K = Uncertainty (vibration)
h
Typical A-weighted sound levels:
L = sound-pressure level
pa
L = Acoustic power level
WA
K , K = Uncertainty
pA WA
The noise level can exceed 80 dB(A) during
operation.
Wear ear protectors!
ENGLISH en
13