Command Line Interface (Cli); Factory Default Settings - Fortinet FortiGate FortiGate-5005-DIST Getting Started

Fortinet fortigate fortigate-5005-dist: user guide
Hide thumbs Also See for FortiGate FortiGate-5005-DIST:
Table of Contents

Advertisement

Factory default settings

Command Line Interface (CLI)

Factory default settings
24
Requirements:
An Ethernet connection between the FortiController-5208 module and
management computer.
Internet Explorer 6.0 or higher on the management computer.
The CLI is a full-featured management tool. Use it to configure the administrator
password, the interface addresses, the default gateway, and the DNS server
addresses.
Requirements:
The serial connector that came packaged with your FortiController-5208
module.
Terminal emulation application (for example, HyperTerminal for Windows) on
the management computer.
Note: Connections to the management computer must be made to the Com 2 interface of
the primary FortiController-5208 module rather than the secondary FortiController-5208 or
any of the individual FortiGate-5005FA2 modules.
The FortiGate-5005-DIST security system unit ships with a factory default
configuration. The default configuration allows you to connect to the console
interface and use the CLI to configure the FortiGate security system for your
network. To configure the FortiGate security system for your network, add an
administrator password, change the network interface IP addresses, add DNS
server IP addresses, and, if required, configure basic routing.
Table 4: FortiGate-5005-DIST factory default settings
Operation Mode
Administrator Account
X1 (port1_X1) IP/Netmask
X2 (port1_X2) IP/Netmask
All other interfaces
Management (mng)
Default route
Primary DNS Server:
Secondary DNS Server:
Note: At any time during the configuration process, if you run into problems, you can reset
the FortiGate security system to the factory defaults and start over. From the web-based
manager go to System > Status, find System Operation at the bottom of the page, and
select Reset to Factory Default. From the CLI enter execute factory reset.
NAT/Route
User Name: admin
Password: (none)
192.168.1.99/24
192.168.100.99/24
0.0.0.0/0.0.0.0
192.168.1.99/24
Gateway: 192.168.100.1
Device: port1_X2
65.39.139.53
65.39.139.53
FortiGate-5005-DIST Security System Getting Started
Quick Configuration Guide
01-30000-0414-20070615

Advertisement

Table of Contents
loading

Table of Contents