Stiga Park Series Instruction Manual page 60

Problem
6. Uneven cutting.
7. Abnormal vibration during
use.
8. With the engine running,
activation of the traction pedal
does not move the machine.
If any of the faults listed below occurs, replace the relevant fuse.
9. All electrical functions are
out of operation. The battery
is charged.
If problems persist after the operations above have been performed, contact your dealer.
Warning! Never attempt to carry out complicated repairs without the necessary tools or
technical ability. Any poorly performed interventions will automatically nullify the warranty
and exonerate the manufacturer from all liability.
Probable cause
The cutting means sharpness
level is low.
Forward speed too high in
relation to the height of the grass
being cut.
The cutting-means assembly is
full of grass.
- Unbalanced cutting devices.
- Slackened cutting devices.
- loose components.
- possible damage.
"Disengage transmission" lever in
the disengaged position.
Fuse 20A blown.
Remedy
Check the tyre pressure.
Contact an authorised assistan-
ce centre.
Reduce the forward speed and/
or raise the cutting height.
- Wait for the grass to dry.
- Clean the cutting-means
assembly.
Contact an authorised assistan-
ce centre for inspection, replace-
ment or repair operations.
Engage the transmission.
Replace fuse 20A.