Post Production Configuration - Videonics MXPro DV User Manual

36 MXP DV U G
RO SER UIDE
Post Production Configuration
The configuration described in this section is useful in a Post-Production environ-
ment—where you mix two or more programs together.
This installation example shows the use of DV equipment in combination with ana-
log equipment.
1
2
3
4
5
6
7
Use the Route function ("Route" beginning on page 92) to make sure your devices
are directed to the correct MXProDV channels.
Connect the Output from a DV VCR to DV IN 1 on the MXProDV rear panel.
Connect the Output from a DV Camcorder to DV IN 2 on the MXProDV rear panel.
Connect a Composite-type monitor to the PREVIEW OUT jack on the rear panel.
Connect a DV recording VCR to the DV OUT jack on the rear panel.
Connect an Output Monitor to the recording VCR so you can see the signal being
recorded.
OPTIONAL – Connect an audio source (CD player, tape deck, or microphone) to
AUDIO IN 4 on the MXProDV rear panel.
Connect the power cord and transformer to the MXProDV rear panel. See "Power
Connector" on page 31 for instructions.
C 3
HAPTER