Using Freeze Effect With Multi-Pips - Videonics MXPro DV User Manual

108 MXP DV U G
RO SER UIDE
2
3
4
5
6
7
8
9

Using Freeze Effect with Multi-PIPs

You can apply the Freeze effect (see "Freeze" on page 97) to any Multi-PIP tile.
To use the Freeze effect with Multi-PIPs:
1
2
3
Assume the graphic of the word "Kong" originates on input C. Press
source C the NEXT source. It serves as secondary input.
Press + to enter Multi-PIP mode. The Preview screen defaults to show config-
SHIFT PIPS
uration 1 (two horizontal tiles). One of the tiles has a flashing border to indicate it is
the current tile. One tile shows the primary input – Kong's head.
If this is the Multi-PIP configuration you want to use, move on to the next step: other-
wise...
a Press the number on the keyboard that corresponds to the PIP configuration you
want to use. (See Table 13, "Multi-PIP Screen Configurations," on page 107, at
the beginning of this section.) MXProDV displays the configuration on the Pre-
view screen.
Use the keys to move the flashing border to a tile where you want to display
ARROW
the secondary input source: or, press
end of a row or column.
Press / . Channel C, in this example, carries the video of the graphic word
NEXT C
"Kong." That image appears in the tile you selected in the preceding step.
Repeat the two preceding steps for any other tile or tiles you want to carry the sec-
ondary input signal.
You can direct any input signal (primary or secondary) to any tile.
When the Preview screen looks the way you want, press
on the output; or use the
Press + to return to the Preview screen.
SHIFT PIPS
Use the keys to select a Multi-PIP tile.
ARROW
Press .
FREEZE
Press again to release the effect.
FREEZE
+
SHIFT ARROW KEY
- to fade the Multi-PIP to the output.
T BAR
/ to make
NEXT C
to move to the beginning or
to cut to the Multi-PIP
PLAY
C 8
HAPTER